![]() ![]() If the disk is not visible in the system and it is impossible to boot from it, then try restoring it through another computer. If the disk burned out, then fixing it yourself will not work either. You should not use recommendations on turning an ordinary bathroom into a “clean room” or advice like “hit the disk case sharply” on your disk - after such an impact, there is a high probability that you will never recover information at all, even in service center. ![]() It is not recommended to open it yourself, since at home it is impossible to create the “clean room” conditions necessary to troubleshoot inside the sealed unit. If cleaning the contacts did not help, then the problem lies in the HDA itself. You can fix this problem on your own using a clerical eraser and a small screwdriver. If you see some kind of physical defect, try replacing the cable - sometimes this helps, and the hard drive is then detected by the system.Īnother very common problem is the oxidation of the contacts under the controller board. They must be fully functional: no creases, kinks or cracks are allowed. Mechanical failureĭisassemble system unit and check the data cable and power cable that are connected to the hard drive. If the BIOS does not have the ability to specify a hard drive (it is not detected even at a basic level), then you need to check it for mechanical damage. Select the "Load Setup Defaults" item on the "Exit" tab in the BIOS.Remove the lithium battery from the motherboard and wait a bit.If you are unable to make these settings yourself, try resetting the BIOS settings to factory settings. If the hard drive is connected via IDE, then you need to manually specify it in the "Primary IDE Master" parameter. The data transfer cable or the drive itself is damaged (burned out, read head jammed, etc.).įirst, you should check the BIOS: if the hard drive is connected via the SATA interface, then you need to make sure that it is detected automatically.Jumpers set incorrectly (relevant when using the IDE interface).There are several reasons for this unfortunate situation: The first step is to determine why the hard drive is not detected in the system. Is it possible to recover data from a dead hard drive if it is not visible in the system? Let's try to answer this difficult question. But sometimes the problem turns out to be more serious: the disk is not detected by the computer, and therefore it is not possible to read information from it. Recovery from hard drive data is not a difficult task if you approach its solution with certain knowledge. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |